Faculty Development Programmes
- Report on Faculty Development Programme on SolidWorks Software
• The FDP on SOLID WORKS was conducted from 28th January 2016 to 30th January 2016.
• Mr. K V Shiva Sai from CoreCAD Technologies Ltd, Bengaluru conducted the programme and the following topics were explained in both theory and practical sessions.
a.Introduction to SOLIDWORKS.
b.Projection of Points, Lines, planes and solids (Theory).
c.Projection of Points, Lines, planes and solids (Hands on).
d.Development of Surfaces (Theory).
e.Development of Surfaces (Hands on).
f.Isometric Projections (Theory).
g.Isometric Projections (Hands on).
•The session was ended with a post assessment and the faculties were graded based on the assessment.
1.Dr. G S Hebbar
2.Dr. P PalPandian
4.Niranjan S J
5.Ram Kumar N
8.Pritesh H D
10.Darshan S M
- Faculty Development Programme on Bosch Automobile Lab 2016
Date: 8th to 10th August, 2016
Venue: CHRIST (Deemed to be University) Faculty of Engineering, Kengeri Campus
Date: 8thAugust, 2016
FDP started by welcome speech by Professor Kiran.
On day one following instruments functions and its uses were explained by trainers to faculty following by hands on training on them. Topics covered were Two post lift, Tyre changer, Wheel balancing and Pneumatic wrench.
Trainer explain function and method of using of Tyre Changing Equipment
Date: 9thOctober, 2016
Day 2 started with revision of previous day.
Equipments explained that day were Wheel Alignment, Wheel Balancing, A/C Servicing motor and Nitrogen tyre inflator.
Hands on training for wheel Balancing Machine Wheel Alignment Demo by Trainer
Date: 10thAugust, 2016
Day 3 of the training started with revision of day 1 and day 2. On the day Batteries testing, battery charging and Auto Electrical Bench were studied following by hands on training. At the end of the session Prof. Pritesh provided vote of thanks to faculties and trainers.
Motor / Stator testing Bench
Prof. Hadiya Pritesh
Prof. Ram Kumar
Prof. Kiran K
Prof. Thejaraju R
Prof. Vivek K S
Prof. Punit Kongi
- Faculty Development Programme on ANSYS 14.0
- Faculty Development Programme on Creo 3.0
Date: 12th September, 2015
Venue: Faculty of Engineering, Kengeri Campus
Trainer: Mr.Naveen Kumar G, Application engineer at Trident Tech Labs.
Date: 12th September, 2015
FDP started by welcome speech by Prof.Chennakeshva.
On day one topics such as Introduction to modeling packages and few of the advantages of the Creo 3.0 over older version were discussed followed by discussion on basic commands such as copy, mirror, constraints, sweep, helical sweep, plane, extrude, hole, camper, axis, points. Hands on session were conducted during which various cad models were developed and explained.
Date: 13th September, 2015
Day 2 started with revision of previous class.
Projection of point, lines, planes, solids, section of solid developments, part modeling and modifying commends on part modeling were taught by Mr.Naveen.
Date: 14th September, 2015
Day 3 of the training started with revision of day 1 and day 2. On the day Assembly drawing and its valedictory topic was covered. At the end of the session Prof.Chennakeshva provided vote of thanks to faculties and trainers.